LP研究社 (黑膠唱盤、黑膠唱片收藏分享)

[极速]

这压环是很实用的道具

[Leo Yeh]

http://www.sibatech.co.jp/abis/tonearm.html

SA-1
* The major key to tonearm quality is the sensitivity and stability in retrieving delicate signals, for which the bearings are the determining factor. The SA-1 employs miniature radial bearings for both horizontal and vertical movement. Very high performance is achieved at a reasonable price.
* The rectangular arm-wand is machined from a solid aluminum block having an advantage in rich and tight bass reproduction, as bass sound is mainly recorded in　 the horizontal plane of the groove.
* Tonearm wires run through separate aluminum tubes inside the arm so that stereo separation is maximized.
* Reproduced sound is precise and clean, thanks to hand assembly by highly skilled craftsmen.
* Comes with detachable headshell, phono cable (RCA output plug, or optionally as XLR), screws, washers, wrench and marking pin.

Specifications
Length:	310mm
Spindle center to arm pivot distance:	212mm
Stylus to pivot distance:	228mm
Overhang:	16mm
Cartridge weight:	15-45 grams, including headshell
Net weight:	745g (with headshell attached: 762g)

TA-1
* The major key to tonearm quality is the sensitivity and stability in retrieving delicate signals, for which the bearings are the determining factor. The TA-1 employs a miniature radial bearing for horizontal movement and a miniature pivot bearing for vertical movement. Very high performance is achieved at a reasonable price.
* The body is constructed from a machine-tooled solid aluminum block.
* The hand-assembled arm wand satisfies every vital condition necessary for vibration-free and noise-free reproduction.
* Reproduced sound is precise and clean, thanks to hand assembly by highly skilled craftsmen.
* Comes with detachable headshell, phono cable (RCA output plug, or optionally as XLR), screws, washers, wrench and marking pin.

Specifications
Length:	305mm
Spindle center to arm pivot distance:	216mm
Stylus to pivot distance:	232mm
Overhang:	16mm
Cartridge weight:	15-29 grams, including headshell
Net weight:	580g (with headshell attached: 597g)

[Leo Yeh]

Ikeda 9TS
與9系列的聲音特色一樣，不過0.35mVrms的輸出比9TT高出一倍，比較容易搭配，價格也稍低(USD 2,800)



Tonally it has the same musicality as the other MC cartridges in the "9"-family. No compromises are made also during processing. The 9TS 0, 35mV is about twice as high output voltage compared to the 9TT so that it can be operated without any problems on cheaper phono preamps.

Output Voltage: 0.35mVrms (1kHz 35.4mm/sec., at 45°peak)
Coil Impedance: 6.0 ohms (1kHz)
Appropriate Stylus Force: 2.0grams ±0.2 grams
Frequency Response: 10Hz ～ 45kHz
Channel Separation: over 27dB (1kHz)
Channel Balance: within 1.0dB (1kHz)
Stylus Chip: Oval-shaped solid Diamond
Cantilever: Double layered duralumin pipe.
Weight: 10 grams
Compliance: 7 x 10-6cm/dyne

Ikeda SAI
來自傳奇的9MUSAM，全新毫不妥協的設計，輸出較原來增加，為0.3 mVrms



The "SAI", is the uncompromising advancement of the legendary "9MUSAM" with completely brand new pickup system. Engineers from IKEDA succeeded to transfer the tonal qualities of the 9MUSAM without compromising. The output voltage could be increased through further development in the area of the coil drive to 0, a channel equal 0, 5dB 30mV! The cantilever consists of "Boron" and the diamond is "Micro-Ridge."

MC cartridge: Universal type dedicated to tonearm.
Output Voltage: 0.3 mVrms (1kHz 35.4mm/sec., at 45°peak)
Coil Impedance: 2.5 ohms (1kHz)
Appropriate Stylus Force: 2.0grams ±0.2 grams
Frequency Response: 10Hz ～ 45kHz
Channel Separation: over 30dB (1kHz)
Channel Balance: within 0.5dB (1kHz)
Stylus Chip: Micro-ridge solid Diamond
Cantilever: made of Boron.
Weight: 30 grams
Compliance: 7 x 10-6cm/dyne

[將軍]

Ikeda 9TS
與9系列的聲音特色一樣，不過0.35mVrms的輸出比9TT高出一倍，比較容易搭配，價格也稍低(USD 2,800)



Tonally it has the same musicality as the other MC cartridges in the "9"-family. No compromises are made also during processing. The 9TS 0, 35mV is about twice as high output voltage compared to the 9TT so that it can be operated without any problems on cheaper phono preamps.

Output Voltage: 0.35mVrms (1kHz 35.4mm/sec., at 45°peak)
Coil Impedance: 6.0 ohms (1kHz)
Appropriate Stylus Force: 2.0grams ±0.2 grams
Frequency Response: 10Hz ～ 45kHz
Channel Separation: over 27dB (1kHz)
Channel Balance: within 1.0dB (1kHz)
Stylus Chip: Oval-shaped solid Diamond
Cantilever: Double layered duralumin pipe.
Weight: 10 grams
Compliance: 7 x 10-6cm/dyne

Ikeda SAI
來自傳奇的9MUSAM，全新毫不妥協的設計，輸出較原來增加，為0.3 mVrms



The "SAI", is the uncompromising advancement of the legendary "9MUSAM" with completely brand new pickup system. Engineers from IKEDA succeeded to transfer the tonal qualities of the 9MUSAM without compromising. The output voltage could be increased through further development in the area of the coil drive to 0, a channel equal 0, 5dB 30mV! The cantilever consists of "Boron" and the diamond is "Micro-Ridge."

MC cartridge: Universal type dedicated to tonearm.
Output Voltage: 0.3 mVrms (1kHz 35.4mm/sec., at 45°peak)
Coil Impedance: 2.5 ohms (1kHz)
Appropriate Stylus Force: 2.0grams ±0.2 grams
Frequency Response: 10Hz ～ 45kHz
Channel Separation: over 30dB (1kHz)
Channel Balance: within 0.5dB (1kHz)
Stylus Chip: Micro-ridge solid Diamond
Cantilever: made of Boron.
Weight: 30 grams
Compliance: 7 x 10-6cm/dyne

SAI的發音念"賽"."塞".但也可以台語發音叫"@#$%&"....昏倒!!

[Leo Yeh]

來一顆High End的SAI吧~~~~~~~~~~~~

[BBWW]

請問站長及先進，

FR唱臂你會推薦什麼品牌唱頭？
池田是否比光悅較好搭配？敬請指教。
感謝。

[將軍]

請問站長及先進，

FR唱臂你會推薦什麼品牌唱頭？
池田是否比光悅較好搭配？敬請指教。
感謝。

1.重質量的唱頭,優先為FR7,其次是IKEDA,最後是Ortofon SPU系列.
2.沒有誰比較好的問題,是口味是否合乎你的問題!!

[kevintran]

1.重質量的唱頭,優先為FR7,其次是IKEDA,最後是Ortofon SPU系列.
2.沒有誰比較好的問題,是口味是否合乎你的問題!!

第二點真是良言啊！最近看到MyAV有位以前玩的很兇的網兄不玩了，還忠告大家要量力而為。貴的音響／唱片當然極有可能在性能或效果上完全超越我們現有的音響／唱片，可是那真的是合乎我們的口味？還是只是因為別人說好？如果有能力能試試看當然最好，沒能力就算了，反正還有很多別的東西可試可玩。聽音樂玩音響，最有趣的地方就是，不管預算高低，都有得玩。沒什麼錢就聽聽網路收音機，還是一樣可以聽的很開心啊！這是個消遣，拿來比誰強誰弱的遲早會burn－out的。人生苦短，何必跟自己過不去呢？

[hojuiyang111]

第二點真是良言啊！最近看到MyAV有位以前玩的很兇的網兄不玩了，還忠告大家要量力而為。貴的音響／唱片當然極有可能在性能或效果上完全超越我們現有的音響／唱片，可是那真的是合乎我們的口味？還是只是因為別人說好？如果有能力能試試看當然最好，沒能力就算了，反正還有很多別的東西可試可玩。聽音樂玩音響，最有趣的地方就是，不管預算高低，都有得玩。沒什麼錢就聽聽網路收音機，還是一樣可以聽的很開心啊！這是個消遣，拿來比誰強誰弱的遲早會burn－out的。人生苦短，何必跟自己過不去呢？

那位不玩了.......?

[kevintran]

那位不玩了.......?

就那位會癢又要跑操場的啊！